Steel braided brake lines.

[Steven Bixby]

I have a set of Galfer front brake lines that have never been used; I sold
my GPZ so they're "orphaned".  When I ordered them, I specified +4" length
with the expectation that I would add risers, so if you already have
risers, it'd be perfect for you.

This set goes with the standard (?) Galfer setup where lines to both
calipers go straight from the master cylinder banjo bolt, and comes with a
dual-banjo compatible bolt.

I also bought a rear line, but that was on the bike when I sold it, so it's
gone. :-/



On Wed, Nov 13, 2013 at 6:20 AM, walkerjl at charter.net
<walkerjl at charter.net>wrote:

> I have to rebuild my rear master cylinder and was thinking it is an
> opportune time to replace my original brake lines. So what's a good source
> for them?
>
> Sent from my Verizon Wireless 4G LTE DROID
> ______________________________________________________________________
> GENERAL GPZList MAILING LIST INFORMATION:
> This is from the GPZList mailing list. GPZList at micapeak.com
> http://micapeak.com/mailman/listinfo/gpzlist
> You subscribed to this mailing list. Therefore, you solicited all
> mail that you receive from this list. Therefore, ANY mail that you
> receive from this list is, by definition, NOT Spam, and if you report
> it as such, you are violating the micapeak.com terms of service.
>
> To unsubscribe, you may send email to gpzlist-unsubscribe at micapeak.com
> ______________________________________________________________________
> YOUR PERSONAL SUBSCRIBER OPTIONS:
> Unsubscribe or choose new options at
> http://micapeak.com/mailman/options/gpzlist/steven%40bixbys.net
> You are subscribed at the email address STEVEN at bixbys.net
> ______________________________________________________________________
>