countershaft sprocket cover

[Stephen Hampson]

You need to remove the clutch slave cylinder as you need to move it out of
the way to get the cover off. Also the top left bolt on the cylinder (IIRC)
also holds the cover on. There are two locating dowels that tend to corrode
and grip the cover so a bit of wiggling and gentle persuasion is needed.

Cheers
Steve

-----Original Message-----
From: gpzlist-bounces at micapeak.com [mailto:gpzlist-bounces at micapeak.com] On
Behalf Of Don Wilcox
Sent: 16 September 2013 00:44
To: Stephen Hampson
Subject: Re: countershaft sprocket cover

I know this sounds stupid,  but last time I had mine off,  I missed one
bolt on the bottom that was covered with crud. After finding that,  massage
with rubber mallet until loose.
Don in Longmont
______________________________________________________________________
GENERAL GPZList MAILING LIST INFORMATION:
This is from the GPZList mailing list. GPZList at micapeak.com
http://micapeak.com/mailman/listinfo/gpzlist
You subscribed to this mailing list. Therefore, you solicited all
mail that you receive from this list. Therefore, ANY mail that you
receive from this list is, by definition, NOT Spam, and if you report
it as such, you are violating the micapeak.com terms of service. 

To unsubscribe, you may send email to gpzlist-unsubscribe at micapeak.com
______________________________________________________________________
YOUR PERSONAL SUBSCRIBER OPTIONS:
Unsubscribe or choose new options at
http://micapeak.com/mailman/options/gpzlist/shampson%40gmx.co.uk
You are subscribed at the email address shampson at gmx.co.uk
______________________________________________________________________


-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3408 / Virus Database: 3222/6668 - Release Date: 09/15/13

-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.3408 / Virus Database: 3222/6665 - Release Date: 09/14/13