Carb Rebuild - Float Height

[Gmail]

Great, thanks Art

Thanks


-Peter Weaver

> On Jun 20, 2015, at 6:31 PM, Art Johnson <art-j at shaw.ca> wrote:
> 
> Pete that is the correct dimension.
> 
> Sent from my iPhone
> 
>> On Jun 20, 2015, at 6:02 PM, pete weaver <peteweaver at gmail.com> wrote:
>> 
>> Hi Guys, I have a 95 gpz1100 that I'm tryng to ressurect.  It has pod
>> filters and I'm assuming a jet kit in it.
>> 
>> I don't have a book for it and I'm trying to set the float heights.  I have
>> read that they are the same carbs as the early zrx1100 (which I do have a
>> book for) and so I am setting the float height to 18.5 mm as indicated in
>> the zrx1100 book.
>> 
>> Can anyone confirm that this is the correct height?
>> 
>> Thanks,
>> 
>> -Pete
>> ______________________________________________________________________
>> GENERAL GPZList MAILING LIST INFORMATION:
>> This is from the GPZList mailing list. GPZList at micapeak.com
>> http://micapeak.com/mailman/listinfo/gpzlist
>> You subscribed to this mailing list. Therefore, you solicited all
>> mail that you receive from this list. Therefore, ANY mail that you
>> receive from this list is, by definition, NOT Spam, and if you report
>> it as such, you are violating the micapeak.com terms of service.
>> 
>> To unsubscribe, you may send email to gpzlist-unsubscribe at micapeak.com
>> ______________________________________________________________________
>> YOUR PERSONAL SUBSCRIBER OPTIONS:
>> Unsubscribe or choose new options at
>> http://micapeak.com/mailman/options/gpzlist/art-j%40shaw.ca
>> You are subscribed at the email address art-j at shaw.ca
>> ______________________________________________________________________
>